TECMEN PAPR FREFLOW WAIST BELT
Here’s a step-by-step guide for replacing the waist belt on Tecmen FreeFlow V1 and V3 PAPR blower unit models:
- Locate the four fixing screws on the back of the waist belt. These screws secure the belt to the blower unit.
- Use a screwdriver to remove the four fixing screws from the back of the belt. Set the screws aside in a safe place.
- Carefully slide the old waist belt off of the blower unit. Depending on the condition of the old belt, it may be tight and require some force to remove.
- Position the new waist belt onto the blower unit, making sure that it is aligned correctly with the screw holes.
- Insert the four fixing screws through the new belt and into the rear of the blower unit. Use a screwdriver to tighten the screws, but be careful not to overtighten them, as this could damage the belt or the blower unit.
- Once all four screws are securely fastened, test the new waist belt by turning on the blower unit and wearing the PAPR as you normally would. Make sure the belt fits properly and is comfortable to wear.
That’s it! With these simple steps, you should be able to replace the waist belt on your Tecmen FreeFlow V1 or V3 PAPR blower unit with ease. If you have any questions or concerns, don’t hesitate to reach out to the manufacturer or a qualified technician for assistance.
Part: V1BE TM3 00 (23 20 01) SAFE3869
Click here to read some important safety measures for welding